Delivering Mountain Park Premium Bottled Water to Homes and Businesses service@mountainparkwater.com
Winston-Salem Greensboro High Point Martinsville Danville
336-761-0884 336-272-6581 336-885-7275 276-632-7800 434-822-5553
Water Dispenser Care and Cleaning
The International Bottled Water Association recommends sanitizing your water dispenser 1-2 times per year.
Example of a No-Spill Device
Cut-Away Image of a standard Reservoir (including No-Spill and Baffle)
Complete Spigot
Unplug unit if plugged in.
Drain residual water through cold faucet.
Remove no spill device (if equipped), baffle, and spigots.
Disassemble no spill device (if equipped), spray with degreaser such as 409, and scrub.
Wipe baffle with clean cloth.
Disassemble spigots and scrub clean.
Remove ice ring from inside reservoir.
Wipe out reservoir with clean cloth.
Reinstall baffle and faucets.
Insert rubber plug into hot tank feed to prevent sanitizing solution from entering hot tank.
Fill reservoir with clean water, add one (1) teaspoon 5ΒΌ% standard Clorox solution to produce 100 ppm chlorine sanitizer and let stand 5 minutes.
Drain sanitizer through faucet(s) for at least 1 minute
Flush with clean water (If you suspect Clorox solution may have gotten into the hot tank, remove hot tank drain and allow to drain prior to flushing with clean water.)
Reassemble no spill device (if equipped) and reinstall (make sure air filter is dry)
Install new bottle.
Plug in unit to electrical receptacle.
